Model 9201EW Emergency Valve thermostatically mixes hot and cold water to provide a safe fluid supply for a single emergency eye/face wash. Additionally, to ensure a fail-safe water supply for emergency eyewash stations, a cold water by-pass valves open in the event of hot water pressure loss. (No gauges supplied – ASSE 1071 standard recommends gauges be placed 5 to 8 feet (1.52 to 2.44 m) downstream for the most accurate temperature measurement.)

• A flow rate of 1 to 10 gpm (3.8 to 37.8 L) for better temperature control across the operating range
• AXION’s superior design and technology provide a complete safety solution for increased victim comfort.
• Wax based thermostat technology for fast response time with proven highly reliable temperature control
• Cold Water Bypass flow rate of 3.8 gpm (14.4 L) (When tested under conditions specified in ASSE 1071)
• Brass valve design with supplied check valves
• Over-sized valve seats resist failures caused by foreign matter
• Efficient funnel design improves temperature control at low flow rates
• Outlet temperature is factory set to 85° F (29° C).
• Tempered water: High temperature limit is factory set to 90° F (32° C).
• For important installation information, please read Scald Warning.

CSA Listings: CSA certified per ASSE 1071, ANSI/ISEA Z358.1, NSF/ANSI/CAN 372, and applicable sections of CSA B125.3.

Model 9201H, low-lead Emergency Valve (patent pending), thermostatically mixes hot and cold water to provide a safe fluid supply for emergency showers and eyewash equipment. The valve contains a secondary high temperature limit valve to provide additional protection to the user in the event of main tempering valve malfunction. Additionally, to ensure a fail-safe water supply for emergency shower and eyewash stations, a series of cold water by-pass valves open in the event of hot water pressure loss. (No gauges supplied – ASSE 1071 standard recommends gauges be placed 5 to 8 feet downstream for the most accurate measurement.)

• Optional recessed or surface mounted valve box available
• A flow rate of 1 to 31 gpm (3.8 to 117.3 L) for better temperature control across the operating range
• AXION’s superior design and technology provide a complete safety solution for increased victim comfort
• Lowest internal pressure drop for this class of valve (advantage where supply pressure is low)
• Wax based thermostat technology for fast response time with proven highly reliable temperature control
• Highest Cold Water Bypass flow rate in the industry (65% of rated tepid flow rate)
• Low-lead brass valve design with internal check stops
• Oversized valve seats resist failures caused by foreign matter
• A new and efficient shuttle design eliminates valve sticking
• A custom funnel design improves temperature control at low flow rates
• Outlet temperature is factory set to 85° F (29° C)
• Tempered water: High temperature limit is factory set to 87° F (30° C)
• Cold water by-pass valves are closed during normal operation, regardless of flow rate

Listings: CSA certified per ASSE 1071, ANSI Z358.1, applicable sections of CSA B125.3, NSF/ANSI 372, NSF/ANSI 61-section 8, California Health and Safety Code 116875 (AB 1953).

Model 8901RFK body spray features a ABS plastic head, stay-open squeeze lever valve, 8 foot (243.8 cm) hose and installation kit. Kit includes clamp hook-up, tee clips and fitting for retrofit installation on most combination shower and eyewash units. Supply: 1/2″ IPS.

In order to comply with state codes the use of a vacuum breaker is required with all hand held body spray units (Haws offers model SP212) Per ANSI/ISEA Z358.1, “Hand held drench hoses provide support for emergency shower and eyewash units, but shall not replace them.”

Haws 8904 deck mounted eye/face wash features the medically acclaimed AXION MSR eye/face wash head assembly (patent pending). This revolutionary inverted flow design is the only product on the market that provides a Medically Superior Response consistent with all EMT, emergency room and doctors’ office protocols by sweeping contaminants away from the vulnerable nasal cavity. Traditional eye washes irrigate from the outside edge of the eye back toward the nose, where contaminants can then be flushed into the nasal cavity through the lacrimal punctum, nature’s ocular cavity drain. Unit is activated with simple squeeze lever operation.

• Eyewash streams provide Zero Vertical Velocity™ stream engineering with even laminar flow for enhanced comfort, stability and effectiveness
• Dust cover allows for the 8904 to stay protected from debris when not in use
• Easily detected and maintained, emergency equipment is equipped with safety sign and test card to record weekly testing
• 8 foot (243.8 cm) green hose provides an extended coverage area to further optimize the irrigation process
• In order to comply with state codes the use of a vacuum breaker is required with all hand held eye/face wash body spray units (Haws offers model SP212)

Certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment.

Haws 8905 features the medically acclaimed AXION MSR eye/face wash head assembly (patent pending). This revolutionary inverted flow design is the only product on the market that provides a Medically Superior Response consistent with all EMT, emergency room and doctors’ office protocols by sweeping contaminants away from the vulnerable nasal cavity. Traditional eye washes irrigate from the outside edge of the eye back toward the nose, where contaminants can then be flushed into the nasal cavity through the lacrimal punctum, nature’s ocular cavity drain. Unit is activated with simple squeeze lever operation.

• Eyewash streams provide Zero Vertical Velocity™ stream engineering with even laminar flow for enhanced comfort, stability and effectiveness
• Dust cover allows for the 8905 to stay protected from debris when not in use
• Easily detected and maintained, emergency equipment is equipped with safety sign and test card to record weekly testing
• 12 foot (365.8 cm) yellow recoil hose provides an extended coverage area to further optimize the irrigation process
• In order to comply with state codes the use of a vacuum breaker is required with all hand held eye/face wash body spray units (Haws offers model SP212)

Certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment.

Model 9001 emergency alarm and light system features an amber flashing light and 90 db at 10 feet (304.8 cm), buzzer that is operated by a double pole, double throw flow switch. Unit is activated when the emergency shower or eyewash is in operation. System can be mounted to pipe or wall. Unit is recommended to be installed where a shower or eyewash is installed in a remote or noisy location where user is unable to summon help.

• Brightly flashing amber light and 90 db buzzer brings immediate attention to an emergency situation
• Switch will activate at 2.4 gpm (9.1 L)
• Voltage: 120 VAC, 50 or 60 cycles. Supply: 1-1/4″ NPT
• This alarm contains a multiple set of contacts for remote activation alarm sites
• Model 9001 is QPS-C-US-Certified-Electrical-Safety, TYPE 4 (Nema 4 equivalent).
• TYPE 4X is also available. Contact Haws for additional information.

Model 9001.5 emergency alarm and light system features an amber flashing light and 90 db at 10 feet (304.8 cm), buzzer that is operated by a 1/2″ NPT double pole, double throw flow switch. Unit is activated when the emergency eyewash is in operation. Switch will activate at 1.5 gpm (3.8 L). System can be mounted to pipe or wall. Unit is recommended to be installed where all eyewashes are installed in a remote or noisy location where user is unable to summon help. Voltage: 120 VAC, 50 or 60 cycles. Power consumption of 14 Watts, 0.12 amp yield. Supply: 1/2″ IPS. This alarm contains multiple sets of contacts for remote activation alarm sites.

Model 9001.5 is QPS-C-US-Certified-Electrical-Safety, TYPE 4. (Nema 4 equivalent)
TYPE 4X is also available. Contact Haws for additional information.

Model 9001.5TYPE4X emergency alarm and light system features an amber flashing light and 90 db at 10 feet (304.8 cm), buzzer that is operated by a double pole, double throw flow switch. Unit is activated when the emergency shower or eyewash is in operation. System can be mounted to pipe or wall. Unit is recommended to be installed where a shower or eyewash is installed in a remote or noisy location where user is unable to summon help.

• Brightly flashing amber light and 90 db buzzer brings immediate attention to an emergency situation
• Switch will activate at 2 gpm (7.6 L)
• Voltage: 120 VAC, 50 or 60 cycles. Supply: 1/2″ IPS
• This alarm contains a multiple set of contacts for remote activation alarm sites
• Model 9001.5TYPE4X is CSA electrical certified, TYPE 4X. (Nema 4X equivalent)

Model 9001ExP Class 1, Division 2, Groups B, C and D emergency alarm and light system features a red flashing light and 90 db at 10 feet (304.8 cm), buzzer that is operated by a double pole, double throw flow switch. Unit is activated when the emergency shower or eyewash is in operation. Switch will activate at 2.4 gpm (9.08 L). System can be mounted to pipe or wall with optional wall bracket that is provided. It is recommended to install unit where a shower or eyewash is in a remote or noisy location where user is unable to summon help. This alarm contains a multiple sets of contacts for remote activation alarm sites. Model is QPS-C-US Certified, TYPE 4. (Nema 4 equivalent). Temperature code T2C Voltage: 120 VAC, 50 or 60 cycles. Supply: 1-1/4″ IPS.

Model 9001EXPC1D1 emergency alarm and light system features an red flashing light and 90 db at 10 feet (304.8 cm), buzzer that is operated by a double pole, double throw flow switch. Unit is activated when the emergency shower or eyewash is in operation. Switch will activate at 2.4 gpm (9.08 L). System can be mounted to pipe or wall. Unit is recommended to be installed where a shower or eyewash is installed in a remote or noisy location where user is unable to summon help. Voltage: 120 VAC, 50 or 60 cycles, Class 1 Div 1, Group C & D. Supply: 1-1/4″ IPS. This alarm contains a multiple set of contacts for remote activation alarm sites. Model 9001EXPC1D1 is QPS-C-US Certified, TYPE 4 (Nema 4 equivalent). Temperature code T4

Model 9001TYPE4X emergency alarm and light system features an amber flashing light and 90 db at 10 feet (304.8 cm), buzzer that is operated by a double pole, double throw flow switch. Unit is activated when the emergency shower or eyewash is in operation. System can be mounted to pipe or wall. Unit is recommended to be installed where a shower or eyewash is installed in a remote or noisy location where user is unable to summon help.

• Brightly flashing amber light and 90 db buzzer brings immediate attention to an emergency situation
• Switch will activate at 2.4 gpm (9.1 L)
• Voltage: 120 VAC, 50 or 60 cycles. Supply: 1-1/4″ IPS
• This alarm contains a multiple set of contacts for remote activation alarm sites
• Model 9001 is CSA electrical certified, TYPE 4X. (Nema 4X equivalent)

Model 9008 cart designed to transport all stainless steel portable eyewashes. Unit is constructed of heavy-duty 1″ (2.5 cm) tubular frame with grey powder-coated finish, features rubber wheels, and is equipped with a ratchet tie down strap to securely hold the tank to the cart.

Trouble viewing this website?

Without an up-to-date browser, you may have trouble with some of our features.

Update Now

Edge

Firefox

Chrome